Cub Cadet Time Save - Manual (Page 25)

Off-Season
Storage &
Parts and
Accessories
Preparing the Engine
For engines stored over 30 days:
To prevent gum from forming in fuel system or on
carburetor parts, run engine until it stops from lack
of fuel or add a gasoline additive to the gas in the
tank. If you use a gas additive, run the engine for
several minutes to circulate the additive through the
carburetor—after which the engine and fuel can be
stored up to six months.
While engine is still warm, change the oil.
Remove spark plug and pour approximately 1 oz.
(30 ml) of engine oil into the cylinder. Pull the recoil
starter several times to distribute the oil, and reinstall
the spark plug.
Clean engine of surface debris. 1.
2.
3.
4.
Preparing the Lawn Mower
When storing the mower in an unventilated or metal
storage shed, care should be taken to rustproof
the equipment. Using a light oil or silicone, coat the
equipment, especially any springs, bearings, and
cables.
Remove all dirt from exterior of engine and equip-
ment.
Follow lubrication recommendations.
Store equipment in a clean, dry area. Do not store
in an area where equipment is present that may use
a pilot light or has a component that can create a
spark. •
•
•
•
WARNING: Never store lawn mower with fuel in tank indoors or in poorly ventilated areas where fuel
fumes may reach an open flame, spark, or pilot light as on a furnace, water heater, clothes dryer, or
gas appliance.
Off-Season Storage
Replacement Parts
Download a complete Parts Manual free of charge at www.cubcadet.com or call 1-800-965-4CUB to
purchase a Parts Manual. Be sure to have the model number and serial number ready. Refer to page
two for more information regarding model and serial number location.
G
E N
U I N
E
FA
CTO
RY PA
RT
S
33-inch Wide Cut Mower Accessories
Bagger Kit 19A-119
Accessories
Description Part No.
Air Filter BS-698413
Battery 725-1704A
Belt, Drive-Transmission (V-type) 954-04145
Belt, Deck Engagement (V-type) 954-04139
Belt, Timing 954-04136
Blade, Spindle Assembly LH 618-04438
Blade, Spindle Assembly RH 618-04439
Cable, Drive 746-04343
Cable, Trans Brake RH 746-04344
This Operator’s Manual
may cover a range of
product specifications for
various models. Char-
acteristics and features
discussed and/or illus-
trated in this manual may
not be applicable to all
models.
Description Part No.
Cable, Blade Control 746-04346
Cable, Throttle/Choke 746-04355
Cable, Trans Brake LH 746-04361
Deck Blade 942-04154
Fuel Tank Cap 951-10514
Fuel Filter 751-3013
Ignition Key 725-2054
Spark Plug 759-3336
Tire, Rear 16 x 4 x 8 (rim and tire) 634-04349
Tire, Front Caster 8 x 1.75 634-04345