Motion, Privacy – COP-USA CHLP100IR-EF User Manual
Page 4

5. MOTION
DETECT MODE
ON/OFF
MD DISPLAY
ON/OFF
DETECT AREA
CENTER/OUT/UPPER/WHOLE/USER
USER AREA
NOT USE/NOT USE/NOT USE/NOT USE/SET
SENSITIVITY
0~8
ALARM TIME
1SEC~60SEC
INITIAL
DETECT MODE (ON/OFF)
This Function allows to identify the area where the motion is detected
MD DISPLAY(ON/OFF)
This Function allows to identify the area where the motion is detected
DETECT AREA (ON/OFF)
This Function allows to identify the area where the motion is detected
USER AREA(ON/OFF)
This Function allows to identify the area where the motion is detected
SENSITIVITY(ON/OFF)
This Function allows to identify the area where the motion is detected
ALARM TIME(ON/OFF)
This Function allows to identify the area where the motion is detected
6. PRIVACY
AREA
1~4
MASK
ON/OFF
COLOR
BLACK / GRAY / WHITE
START X
0~187
END X
2~189
START Y
0~124
END Y
2~126
INITIAL
AREA
This camera has up to 8 masking areas. These 8 Masking Areas can be setup anywhere in the screen.
and each mask can be enabled or disabled anytime.
MASK (ON/OFF)
Enables or Disables the Privacy Masks . Make sure you are selecting the right privacy mask, looking at the MASK SELECT number.
COLOR
you can choose from 7 different mask colors.
START X
This sets the start of horizontal part of the mask
END X (ON/OFF)
This sets the end of horizontal part of the mask
START Y
This sets the start of Vertical part of the mask
END Y