Capresso Impressa S Avantgarde Series - Manual (Page 24)

• Push and hold the Dial. FILTER
• Turn the Dial until the display shows STEAM PORTION .
• Push the Dial. Display shows (example) PORTION 14 SEC.
• Turn the dial to change the steam time to the desired setting.
• Push the dial to confirm. The 3-tone melody confirms the
new setting. STEAM PORTION .
• Turn the Dial to EXIT .
• Push the Dial to get back to SELECT PRODUCT .
16.6 ECONOMY MODES / ECONOMY
You can set the machine to three different modes.
ECONOMY MODE –
The machine is always ready to brew coffee and to produce
steam. The two red indicator lights in the steam buttons are
always on.
ECONOMY MODE 1
The machine is always ready to brew coffee and is in the
energy saving mode for steam.
If the machine is mostly used for coffee this setting will consume
less energy. The heating element for steam will shut off after
approx. 10 minutes after last use. At this time the two red indi-
cator lights in the steam buttons will turn off. If you want to use
the steam function, push one of the steam buttons. The lights
will start blinking, indicating that the thermoblock for steam is
heating up. This will take between 5 and 30 seconds depending
how much the thermoblock was cooled down. Once the red
indicator lights in the steam buttons are illuminated, you can
push them again and steam will be produced.
ECONOMY MODE 2
This setting will save more energy than economy mode 1.
Choose this setting if you prepare only a few coffees or cappuc-
cinos in large intervals. It is much faster than turning the
machine on and off every time you want to make coffee.
Five minutes after last use (coffee or steam), the machine will
lower the temperature of the thermoblock for coffee. When
making coffee at a later time, the machine will first heat up. This
will take between 5 and 30 seconds.
SELECT PRODUCT
• Push and hold the Dial. FILTER
• Turn the Dial until the display shows ECONOMY MODE - .
• Push the Dial and turn to the desired setting e.g. ECONOMY
MODE 1 .
• Push the dial to confirm. The 3-tone melody confirms the
new setting. The display will show the new setting,
ECONOMY MODE 1 .
Turn the Dial to EXIT .
Push the Dial to get back to SELECT PRODUCT .
16.7 ACTUAL TIME / TIME
Setting the time allows you to program an auto-on time.
SELECT PRODUCT
Push and hold the Rotary Dial. FILTER
Turn the Dial until the display shows TIME -.-
• Push the Dial and turn the Dial to set the hours.
• Push the Dial to confirm.
• Now turn the Dial to set the minutes.
• Push the Dial to confirm.
TIME 7:15 AM (example).
The 3-tone melody confirms the new setting.
• Turn the Dial to EXIT .
• Push the Dial to get back to SELECT PRODUCT .
23.