AvaLAN Wireless AW900R2-EVAL - Manual (Page 16)

User’s Manual
PAGE 16 Technical support (650) 384-0000 www.avalanwireless.com
AW900R2-EVAL
FCC Certification
The AW900R2 OEM RF Module complies with Part 15 of the FCC rules and regulations.
Compliance with labeling requirements, FCC notices and antenna regulations is required.
IMPORTANT: The AW900R2 OEM RF Modules have been certified by the FCC for use with
other products without any further certification (as per FCC section 2.1091). Changes or
modifications not expressly approved by AvaLAN could void the user’s authority to operate
the equipment.
IMPORTANT: OEMs must test their final product to comply with unintentional radiators
(FCC section 15.107 and 15.109) before declaring compliance of their final product to Part 15
of the FCC Rules.
IMPORTANT: The AW900R2 OEM RF Modules have been certified for fixed base station
and mobile applications. If modules will be used for portable applications, the device must
undergo SAR testing.
Labeling Requirements
In order to inherit AvaLAN’s FCC Certification, compliance requires that the following be
stated on the device:
Contains FCC ID: R4N-AW900MR
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are
met. This includes a clearly visible label on the outside of the final product enclosure that
displays the contents shown in the box above.
User’s Manual Requirements
In order to inherit AvaLAN’s FCC Certification, compliance requires that the following be
stated in the user’s manual:
Compliance Statement ( Part 15.19 )
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Warning ( Part 15.21 )
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure ( OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile transmitting devices, this transmitter should only be used
or installed at locations where there is at least 20cm separation distance between the antenna and all persons.
Information to the User - Part 15.105 (b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.