AvaLAN Wireless AW2400mTR-EVAL - Manual (Page 9)

PAGE 9 Technical support (650) 384-0000 www.avalanwireless.com
User’s Manual AW2400mTR
LED and Switch Behavior
DIP Switches
1
2
3
4
5
6
7
8
LEDs
PWR
RX
TX
ETH
CH1
CH2
CH4
CH8
CH16
CH32
LINK
QUALITY
Reset Switch:
Press momentarily for soft
reset of processor. Hold for
10 seconds to reset module
to factory defaults.
LED Function Color
PWR Unit has power and has successfully booted Red
RX Radio reception is occuring Green
TX Radio transmission is occuring Green
ETH Ethernet port is connected Green
CH1 By adding the numbers that are lit, you can determine
the current radio channel. Valid channels are 1 to 29.
For the frequency of each channel, see the table on
page 5.
Green
CH2
CH4
CH8
CH16
CH32
Shows link quality
(more lit the better)
or indicates “key
exchange mode” if
blinking sequentially
Excellent link quality: no retransmissions Green
Very good link quality: few retransmissions Green
Good link quality: occasional retransmissions Amber
Fair link quality: some retransmissions Amber
Poor link quality: frequent retransmissions Red
No link quality: no link available Red
DIP Switch Function (up is off, down is on)
1 Set on for Access Point, off for Subscriber Unit
2 Test switch for tech support use. Leave off
3-8 All off: automatic frequency selection. To manually set the chan-
nel, set switches on in same pattern as the channel LEDs: Switch 3
is bit 1, switch 4 is bit 2, switch 5 is bit 4, etc.