AvaLAN Wireless AW2400mTR-EVAL - Manual (Page 11)

PAGE 11 Technical support (650) 384-0000 www.avalanwireless.com
User’s Manual AW2400mTR
To add a new SU to the AP, disconnect the AP from the network and power off.
Connect an Ethernet cable between the SU and AP. Power up the SU FIRST and then
the AP. The SU will receive the key. Disconnect the Ethernet cable and cycle power
on the SU to cause the new keys to take effect.
To re-key SUs to a new AP, proceed as in the inital setup, making sure to power up
the AP FIRST.
Technical specifications
Characteristic Specification/Description
RF transmission rate 1.536 Mbps
Ethernet data rate 935 Kbps
RF Output Power +21 dBm (4 Watts EIRP with 15 dBi antenna)
Receiver Sensitivity -97 dBm at 10 -4 Bit Error Rate
Range Up to 30 miles line-of-sight with 15 dBi antennas
RF channels/bandwidth 29 non-overlapping with 2.0833 MHz spacing and 1.75
MHz bandwidth, automatic or manually selectable via
web browser interface
Connector types RF: RPTNC Female / 10/100 base T Ethernet: RJ-45
Data Encryption 128-bit AES, FIPS197, keys set through password-pro-
tected browser interface
Error correction technique Sub-block error detection and retransmission
Adjacent band rejection SAW receiver filter attenuates cellular and pager inter-
ference
Power regulation Built-in switching regulator
Browser management tools QoS Statistics, Network Settings, Spectrum Analyzer,
Firmware Upgrade
Power consumption Transmit: 1.7 Watts Receive: 0.8 Watts
Voltage 9 to 48 VDC via unused pins in RJ-45 jack - pins 4,5
positive, 7,8 ground
Power regulation Switching regulator
Transmit current draw 140 ma at 12 VDC
Operating Temperature Range -40 ºC to +80 ºC
Size 70 x 66 x 23 mm, 40 grams