AvaLAN Wireless AW58103HTS - Manual (Page 3)

AW58103HTS/ AW58303HTS
PAGE 3 Technical Support (650) 384-0000 www.avalanwireless.com
Addendum
Disregard the power connection information in the attached manual in the Quick Start Guide and
Physical Setup sections, using the information below instead.
We recommend connecting and powering up the unit on the bench before deploying in the field, be-
cause it is much easier to troubleshoot problems and to adjust the configuration if necessary without
having to climb poles to do it. Activate the AW58103HTS units one at a time until they can be given
distinct IP addresses.
This photo shows how things are connected on the bench:
The main elements to consider are these:
• The Power connection is made to the labeled port (the rightmost one when viewed from the
rear) on the radio.
• The maximum cable run between the Power Over Ethernet Injector and the radio is 60 feet (20
meters).
• The maximum cable run from the radio to any of the three attached devices is also 60 feet.
• The POE has a “Data In” socket that can be connected to a network.
• Total DC power available to the three devices is 25 Watts (AW58103HTS) and 75 Watts
(AW58303HTS).
To 120 VAC 60 Hz
power
POE with 48 VDC Power Supply
Power Input
to Radio
Power and
Data Outputs
to Ethernet Devices