Talkswitch M600I - Manual (Page 67)

M600i Control panel 67
This is the Internet version of the user guide. © Print only for private use.
4. Activate the card by setting the Calling
Card Mode to Call directly , Always use
calling card or Prompt before call .
The calling card icon will now be visible
in the status bar. The .pbx file may be set up so
that you can send commands to the
switchboard by tapping the calling card icon.
Call waiting
You can choose if you want the phone to alert
you when you receive an incoming call during
an ongoing call.
Select Tools > Control panel > Call settings >
Call waiting and set this option to On / Off .
If ALS (two lines on the SIM card) is
available, you can set this option to
On/Off on
two separate voice lines.
The settings are made in the network. Select
More > Refresh to receive the current settings.
Divert calls
The phone can divert incoming calls (voice
and data & fax calls) to another number if you
are busy, not reachable or do not reply. You
can also choose to divert all calls.
Select Tools > Control panel > Call settings >
Divert calls and choose which type of calls
that should be diverted and then where to
divert them.
Divert options
Lookup in contacts – select an entry from
the Contacts phonebook.
Enter number – enter a phone number to
be used for diverting calls.
Off – your incoming calls will not be
diverted.
All the divert settings are made in the network.
Select
More > Refresh to receive the current
settings.
Flag Call
Select Tools > Control panel > Call settings >
Flag call to enable the feature. If the feature is
enabled and you reject a call, you will be asked
to set up a reminder to follow it up after a pre-
defined delay that you can choose.
Handsfree settings
Select Tools > Control panel > Call settings >
Handsfree to set how to answer to an
incoming call when handsfree equipment is
connected.
Answering mode
Normal – answer calls as normal.
Any key – press any key on the keyboard
to answer.