Adaptive Technologies AFGS-66-KIT - Manual

© 2006 ATM FLY-WARE Signal Hill, CA 90755 USA (562) 424-1100
11/07
AFGS SERIES
360° AFGS-66 BOLT KIT
Installation Instructions
AFGS-66-KIT (W)
The AFGS-66-KIT is used to connect two AFGS-66G grid to create a full
circle (360°) speaker cluster configuration.
Important: Rigging overhead system requires professional experience.
Improperly installed equipment can result in property damage,
personal injury, death and/or liability to the installing contractor.
Do not suspend if in doubt about the integrity of the structure.
Caution: Due to the wide variety of structures, environments, materials
and rigging methods, these instructions assume that the installing
contractor will exercise good judgment in selecting the proper mounting
area and hardware.
Follow these instructions for the most efficient and safest
mounting results.
Do not exceed the working load limit.
Package Contents:
8 pcs. Hex bolt, ½-13 x 6.5” long
16 pcs Flat washer, ½, USS
8 pcs
Nylock Nut, ½-13
1 pc. Instruction sheet
Note:
AFGS-66G can be connected together with or
without the AFGS-66S spokes attached to the
Grid.
Step 1. Place two AGF-66G grids back to back
creating a circular shape. Makes sure the pad
eyes are all on the same side. Align the holes
on the flat end of the grid so to match with each
other (Figure 1)
Step 2.
Secure the two grids using the hex bolts, flat
washer and nylock nut. Do not tighten bolts until
all the hex bolts are all in the holes (Figure 1).
Step 3.
Tighten bolts permanently (Figure 2).
Step 4.
Check all connections and hardware before hoisting the cluster.
Figure 1
Figure 2