Panasonic RC-X260 - Manual (Page 9)

To Set the Correct Time
To set the correct time on the clock dis-
play, use the following procedure.
1
Connect the AC power cord to
your household AC power out­
let.
The clock display will begin to flash
continuously.
While pressing the off/time set
button, press and hold the time
set buttons until the correct
time appears on the clock dis-
play.
The digits should stop flashing.
To forward or reverse the displayed
time rapidly, press and hold the FAST
button with the FWD or REV button.
To forward or reverse the displayed
time minute by minute, press the
FWD or REV button repeatedly.
The seconds are automatically set to
“0" when the FWD or REV button is
pressed.
Observe the PM indicator. A green
dot (PM indicator) indicates TM” and
no dot indicates “AM”.
3
Set the brightness selector on
the back of the unit to “HIGH**
or “LOW**.
To increase the brightness of the time
display, set this selector to‘‘HIGH"; to
decrease it, set to “LOW".
The correct time can usually be obtained
by listening for time checks on the radio or
from telephone time services.
The time set (REV-FAST-FWD) buttons
can only activate when the offAime button
is pressed.