Panasonic MC-V5710 - Manual (Page 12)

: .t-i:
^ ^
................................................................................................
ttCMGINGiflE BOSTiBAGMia
5. Reinsert the tab pro
vided on the end of the
dust cover into the
grooves on the dust
compartment to ailovir
the cover to rotate
closed.
NOTE: The dust
cover must be
completely and
correctly
installed for
proper oper­
ation.
6. Rotate the dust cover up into
the closed position and press
into place.
NOTE: The dust
bag should not
be caught
between the
lower edge of
the dust cover and
the gasket as indicat­
ed by the arrow In
the illustration.
CLEANING SECONDARY f=QAM RLTER
---------------------------------------------------------- ^=1 --------------- 13 ----------------------
A secondary foam filter protects the
motor from dirt. When installing a new
dust bag, check this filter. Accumulated
dirt in the dust compartment will collect
on the filter and may restrict motor per­
formance. When the filter becomes
dirty, puli it from the bottom of the dust
compartment and clean by rinsing with
water. When dry, slide the filter back
into place. Insert the secondary foam
filter with a ruler or something flat. It
should be fully inserted under the plas­
tic rib project'ons all the way to the rear.
CLEANING FOAM EXHAUST RLTER
The foam exhaust filter is located inside the dust cover.
The purpose of this filter is to remove dust and dirt from
the recirculated air. When installing a new dust bag,
check this filter. When the filter becomes dirty, remove
it from the bottom of the dust cover by pulling It
straight up. Clean the exhaust filter by rinsing with
water. When dry, place the filter back into the dust
cover with the six (6) slots in the filter aligned with
the six tabs on the dust cover.
Exhaust Fitter
Dust Cover
-
12
-