Panasonic CT-2786VYD - Manual (Page 6)

instaOiation
Monitor Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting may reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor­
mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you’ll need.
Power Supply Cord
MAKE SURE PLUG IS INSERTED FULLY INTO RECEPTACLE.
This product is equipped with a three-wire grounding type plug - a plug with
two blades and a third pin which is round. This plug will only fit into a grounding
type outlet.
This is a safety feature. If you are unable to insert the plug into the outlet,
contact your electrician to replace your obsolete outlet. DO NOT DEFEAT
THE SAFETY PURPOSE OF THE GROUNDING TYPE PLUG.
3 Wire Ground Plug
Remote Control Battery Installation (CT-2786VYD only)
Batteries: Use two "AA” batteries.
1. Remove the battery compartment cover on back of
the remote.
Install the batteries in the battery compartment.
(Polarity (+) or (-) must be correct.)
Reattach the battery cover.
To Remove Cover Push In And Up
On Catch With A Narrow Object
2 .
3.
Helpfui Hints:
For frequent Remote Control users, replace old
batteries with Alkaline batteries for longer life.
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter.
Observe the Following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example; “Zinc Carbon” with “Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or bum used
batteries.
5. Battery replacement is necessary when Remote Control reacts
sporadically or stops operating the TV.
-
6
-