Cabletron Systems 3T02-04 - Manual (Page 24)

Chapter 3: Configuring
Page 3-6 Token Ring Switch Module User Guide
ATX> translate
To display the translations that have been activated for indicated ports,
enter
translate followed by a Token Ring port range. For example:
ATX> translate 2-4
To display the options that are available for the specified translation type,
enter:
ATX> translate port range translation type
Token Ring ports may have any combination of the different translation
types. To enable the translation type in the manner specified by option for
the indicated ports, enter:
ATX> translate {port range} {translation type} option
To disable all translation types for the indicated ports enter:
ATX> translate {port range} none
3.6.1 ARP Translation
The ARP translation options are intended to compensate for any likely
implementation of IP's ARP on 802.5 Token Rings. The possibilities for
option are the following:
• Off – no special ARP translation to be performed
• Bitswap1 – embedded MAC addresses for ARP packets with hardware
type 1 (Ethernet) will be bit swapped (this applies to all ARP packets
received by the port, and to all ARP packets to be transmitted by the
port).
• Bitswap6 – embedded MAC addresses for ARP packets with hardware
type 6 (IEEE 802) will be bit swapped (this applies to all ARP packets
received by the port, and to all ARP packets to be transmitted by the
port).
• Bitswap61 – both type 1 and type 6 ARP packets will be bit swapped.
• Oneto6 – incoming type 6 ARP packets will be changed to type 1 and
outgoing type 1 ARP packets will be changed to type 6, both without
bit swapping.