Panasonic CF-M34 series - Manual (Page 12)

First-time Operation
4Windows)2000l
@
©
©
r
Do not press any key or move the touch pad until [Windows 2000 Profes­
sional Setup] is displayed.
V______________ _____ _________ ____________ ___________________
At the [Welcome to the Windows 2000 Setup Wizard], select [Next].
After reading the agreement, select [I accept this agreement] or [I don't accept
this agreement], then select [Next],
note )-
If [1 don’t accept this agreement] is selected, the Windows setup will be
aborted.
V__________________________________________________________
Select settings for your region, then select [Next].
Enter your name and organization and select [Next],
Enter your computer name and administrator password and select [Next],
-(d emiioN
D-
©
@
®
®
( 12 )
Remember this password! If the password is forgotten, Windows 2000 can-
not be operated.________________ _____ _____ _____________ ___________
Input the correct date, time and time zone and select [Next].
You can also complete these settings at a later time.
At the [Networking Settings], select [Typical settings], then select [Next].
At the [Workgroup or Computer Domain], select [No, this computer is not on a
network, or is on a network without a domain], then select [Next],
The computer will restart.
At the [Network Identification Wizard], select [Next].
At the [Users of This Computer], select [Users must enter a user name and pass­
word to use this computer], then select [Next].
Select [Finish],
Enter your administrator password and select [OK],
NOTEy
At the [Getting started with Windows 2000], select [Exit] to close.
(WffiüüwSIÜT)
(T) The License Agreement will be displayed. After reading the agreement, select [I
accept this Agreement].
X note )----------------------------------------------------------------------------------------- ^
If [1 don’t accept this Agreement] is selected, the Windows setup will be
aborted._________________________________________________________ ^
Select [Next].
Input your name and organization, then select [Next], (It is possible to omit the
organization item.)
( 4 ) Input your computer name and select [Next],
Input an Administrator password and select [Next].
^
, emiiiQN
12
Remember this password! If the password is forgotten, Windows NT cannot
be operated.________________ __ _____________
Select [Finish]. Windows will restart.
(2) Following the display, press CctrD+CAlD+CDiD Input the password set in
step( 5 )and select [OK], then select [Close] at the [Welcome] display.
• As the computer starts up, it will be necessary to input the password set in step(8).
@ Set the correct settings for all items in [Control Panel]-[Regional Settings] and
[Date/Time] etc.