Clarion FB275BTB - Manual (Page 10)

10
English
FB275BT / FB275BTB
DX SEEK
When the [ ] button is pressed, search will be
performing in the direction of higher frequencies.
When the [ ] button is pressed, search will be
performed in the direction of lower frequencies.
∗ When seek tuning starts, “DX” appears in the
display.
Radio Operations
Listening to the radio
1. Press the [SRC] button and select the Radio
mode, then the radio will be on.
2. To select a preset band, press the [BND] but-
ton, then select one of the preset bands such
as FM1, FM2 or FM3. Every time the [BND]
button is pressed, the display will change as:
FM1 FM2 FM3 FM1...
3. Press the [ , ] button to tune in the
desired station.
∗ Initial frequency display is “87.50MHz”.
Seek tuning
There are 2 types of seek tuning: DX SEEK and
LOCAL SEEK.
DX SEEK can automatically tune in to receivable
broadcast stations; LOCAL SEEK can tune in to
only broadcast stations with a good reception
sensitivity.
1. Press the [BND] button and select the desired
FM band.
∗ Press and hold the [ BND] button for 1.5 seconds
or longer to switch to Auto Seek mode. Make
sure “SEEK TUNE” is displayed briefly.
2. Press the [ , ] button to start automatic
station tuning.
When the [ ] button is pressed, search
will be performing in the direction of higher fre-
quencies. When the [ ] button is pressed,
search will be performed in the direction of
lower frequencies.
Basic Operations
AUX function
This system has AUX RCA input in the rear panel
where you can listen to sounds and music from
external devices connected to this unit.
1. Connect the external music player to the AUX
RCA input.
2. Enable the AUX function in Adjustment mode.
Please refer “Setting AUX function” on page
27 for more details.
3. Press the [ SRC] button to select the AUX mode
to activate the AUX function.
Note:
Volume can be adjusted through the unit.
Please refer chapter “Common Operations” on
page 26 for more operation controls.
Adjusting the volume
Turning the [ ] knob clockwise in-
creases the volume; turning it counterclockwise
decreases the volume.
“VOLUME 0” to “VOLUME 33” will be displayed
depends on the volume level.
∗ Factory default setting for volume is “VOLUME
13”.