General operation on the tv set, Function ( func.) button, System buttons – Panasonic TC-25V50H EN User Manual
Page 17: System 1 select operation, System n select operation, General operation on the tv set -17, For tv mode only)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General Operation on the TV Set
■
> I
5. Function ( FUNC.) Button
FUNC.
By pushing this button repeatedly, the Picture
Control Function and Sound Control Function
will be displayed.
All functions are set at factory preset level (is
showed in yellow colour).
Press the Volume Up" + " or Down ” - **
buttons to adjust the level of selected functions.
The sequence is as follows :
COLOUR
NTSC^-TINT
BRIGHT
CONTRAST
SHARPNESS
BASS^
TREB^LE
BALANCE
NTSC-TINT will appear
if NTSC 4.43 or NTSC
3.58 is selected.
6. System Buttons
System 1 Select Operation
I-SYS.-I
0
The System button is automatically set
to the AUTO mode. If a clear picture
cannot be obtained when receiving
broadcast or AV signal, push this button
repeatedly until the optimum picture is
received. Push System I button to the
appropriate mode if black and white
picture received is shaking slightly.
When this button is pushed, you change
the on-screen display as shown below :
TC-25V50H
TC-25V50R
TC-2552G
TC-2550R
-►AUTO
-►AUTO
PAL
PAL
f
NTSC 4.43
SECAM
1
NTSC 3.58
______ 1
NTSC 4.43
*
NTSCj 3.58
System n Select Operation
{for TV mode only)
H-SYS.-I
When the sound is not clear or no sound
is produced on channel number selected,
push this button repeatedly until the
optimum sound is obtained.
The selected system mode on each chan
nel number position is automatically
memorized.
The on-screen change as follows :
17