Panasonic EW3006 - Manual (Page 22)

Calling up readings from memory
Readings can be recalled after being saved without having to switch the unit on.
Readings will not be displayed if they have not been saved.
Fig. 11-a
M/R
Fig. 11-b
Fig. 11-c
M/R
Fig. 11-d
1. Press the Memory/Recall button (Fig. 11-a).
• The average reading of all recorded measurements is
displayed.
• The ^3 mark will be displayed (Fig. 11-b).
• When, for example, readings from 90 measurements
have been saved the average of the readings from 90
measurements will be displayed.
• If there is only 1 measurement recorded, mark
will not be displayed.
2. Press the Memory/Recall button to display readings
starting with from the most recent measurement.
• Each time the Memory/Recall button is pressed
readings are displayed in order of the most recent
measurement (Fig. 11-c, 11-d).
3. Press the On/Off and Start button to switch off the unit.
If you forget to switch off the unit It will do so
automatically after approx. 30 seconds.
Deleting all data stored In memory
(1) Recall stored data using the Memory/Recall
button.
(2) Press the Memory/Recall button again and hold
it (tor approx. 3 seconds) until all readings are
deleted.
NOTE: Readings from individual measurements
cannot be deleted.
(3) If everything has been deleted, the (El mark and
00 will be displayed.
21