Installation precautions, Installation of the main control unit, Installation of the display control unit – Panasonic Universal FM Modulator Controller 800EUC User Manual
Page 2: Installation of the antenna switch, Caution, Installation instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions-
Installation Precautions
• This equipment, if possible, should be installed by a professional installer. In case of difficulty, please consult
your nearest authorized PASC, Panasonic (in Canada) Servicenter.
• Before installation and wiring, remove the negative (-) terminal of the battery.
Note
: For installation in cars with trip or navigational computers, all electronic memory settings previously regis
tered in the computer will be lost when the battery terminal is disconnected. For this type of car, the battery should
not be disconnected. Therefore, extra care should be taken to prevent short circuiting.
• Insulate all exposed wires to prevent short circuiting.
• Avoid installing the remote control unit or the Display Control Unit in a place where it may be exposed to direct
sunlight and high temperature.
Supplied Hardwares
Description
Q’ty.
Magic Tape
1
1. Installation of the Main Control Unit
Mount the Main Control unit on the carpet.
2. Installation of the Display Control Unit
Mount the Display Control Unit on the console.
Separate the magic tape and put them on the
face of the console not to lean the Unit.
3. Installation of the Antenna Switch
Mount the Antenna Switch on the inner side of the console.
n
Caution:
Please wipe clean the face of the console to put on
the magic tape.