Yamaha A100 - Manual (Page 5)

POWER AMPLIFIER
^lOO
SPECIFICATIONS
Input jacks:
Output connectors:
Functions:
Rated output:
Input sensitivity:
Voltage gain:
Frequency response:
Power bandwidth:
Total harmonic distortion:
intermodulation distortion:
Channel separation:
Signal to noise ratio:
Residual noise:
Slew rate:
Damping factor:
Input impedance:
Power requirement:
Power consumption:
Dimensions (W x FI x D):
Weight:
Standard Accessory:
Pin jack
X
1/ch, Phone jack x 1/ch
4P push terminals
POWER switch, OUTPUT LEVEL controls, Level meters,
CLIP indicators, MODE switch (ST/MONO)
BOW + BOW (stereo, 1 % THD, 8 Ohm)
100W (BTL mono, 1% THD, 16 Ohm)
-10 dB (24B mV), (1 kHz,^B0W/8 Ohm, vol. max.)
38.2 dB (1 kHz, input-10 dB) ,
20 Hz — 20 kHz (0 + O.B dB)
10 Hz — BO kHz (0.2% THD, 2BW/8 Ohm)
0.02% (1 kHz, 2BW/8 Ohm, stereo)
0.2% (20 Hz — 20 kHz, 2BW/8 Ohm, stereo)
0.2% (70 Hz : 7 kHz = 4 : 1, 2BW/8 Ohm, stereo)
70 dB (1 kHz), 60 dB (20 Hz — 10 kHz)
10B dB (input shorted, IHF A)
-77 dB (vol. min., IHF A)
10 V/|j.sec. (full swing, 8 Ohm, stereo)
Grater 70 (1 kHz/8 Ohm), grater 60 (20 Hz — 20 kHz, 8
Ohm)
Grater 7.B kOhm
U.S Model: AC 120 V 60 Hz
General Model: AC 220/240 V BO/60 Hz
U.S Model: 120 W
General Model: 120 W
220
X
96
X
296
mm
(8-11/16"
X
3-3/4"
X
11-B/8")
4.6 kg (10 lbs. 2 oz)
Operation manual
0 dB = 0.77B V rms
Specifications and design are subject to change without notice.
4