Panasonic RAK-P001 - Manual (Page 7)

COMPONENT SET-UP Panasonic
TV/VCR/SATELLITE/AUX SET-UP:
1. Make sure that the component (TV, VCR, Satellite, or AUX)
which you want to set up has been turned on.
AUX = DVD, cable, or an additional TV, vCR, or cable,
in the codebook (section #2), find the 4-dlg!t code
numbers for your component brand.
2. Press the key of the component that you want to
set up. (TV. VCR, SAT, AUX)
3. Press the "set up'
should be on.
key. Both the green and red lights
4. Press the key of the component that you want to set up.
(TV, VCR, SAT, AUX) Only the red light should be on.
5. Within thirty seconds, enter In a 4-diglt code number
The component lights will blink with an upward motion
when a code has been successfully entered.
In this case,
proceed to step 6. If the code has not been successfully
entered, the red light will blink alone, in this case, return
to step 1 and start over.
6. Test code by pressing "Power" key. if the component
turns off, you've got the right code. Follow the same
instructions to set up your other components. If the
component doesn't turn off, return to step 2 and use the
next 4-digit code listed.