Panasonic RAK-P001 - Manual (Page 14)

Panasonic TROUBLESHOOTING
Problem:
• No power In remote (no light).
• The component lights do not blink
with an upward motion after the
code was entered-
• Code enters Into remote, but the
component does not respond.
• None of the codes work the
component.
Solution:
Check battery installation and
battery freshness. Press
"set up" to see if the red and
green lights both come on.
Enter the code within thirty
seconds after you press
"set up". Tty the code again or
the next code on the list.
Try the next code on the list,
one of the codes should work
your component.
After trying all the codes, call
customer service at;
1-888-400-PANA
HELPFUL HINTS
• Enter only one four-digit code at a time.
• The first code listed isn't always the one for your component, some work
better than others, therefore try them all.
• Enter the code within thirty seconds after pressing "set up".
• The most often used code for each brand is listed first.
• If you replace the batteries within 25 minutes after they have been taken
out, the codes which you have programmed will be retained.
• If you have any problems or questions, call customer service at
1-888-400-PANA.
1A