Panasonic KX TG2396B - Manual (Page 2)

Getting Started
1-A Accessories 1-B Location of Controls
□ AC Adaptor................... one
Order No. PQLV1Z
Handset
□ Telephone Line Cord
.one
TALK Indicator
(2-A)
□ Belt Clip........................ one
Order No. PQKE10084Z1
• For extra orders, call
1-800-332-5368.
Base unit
Antenna
f — Antennas ( 1 -C)
IN USE
Indicator (5-F)
Charge Contacts
(6-B) :
(TALKI Button
(2-A)
[REDIAL]
Button (2-A)
(CH) (Channel)
Button (2-A)
[FLASH] Button
(5-A, 5-B)
RECHARGE
Indicator (6-B)
Headset Jack (1-E)
[DIRECT] Button
(4-A)
Navigator Key
(LOUD/RINGER ®,®
PROGRAM 3, AUTO 0)
(1-C, 2-A, 2-B. 3-A, 5-A)
[TONE] Button (5-D)
[PAUSE] Button (5-E)
Charge Contacts (6-B)
CHARGE Indicator
(1-C) ^^
[HANDSET LOCATOR]
Button (5-F)
1-C Settings
Connect as shown. Raise the antennas.
3
:
Charge the battery for 7 hours
See section 6-B for more details.
The CHARGE indicator lights.
CHARGE Indicator
Single-Line
Telephone Jack (RJ11C)
J Telephone Line Cord
• USE ONLY WITH Panasonic AC ADAPTOR PQLV1
(Order No. PQLV1Z).
• The AC adaptor must remain connected at all times.
(It is normal for the adaptor to feel warm during use.)
• To connect a standard telephone on the same line,
see section 6-D.
To select the dialing mode TONE (preset) or PULSE
You can program the dialing mode using the handset near the base
unit. The TALK indicator light must be off before programming.
(D twice (PULSE)
Press PROGRAM 0 ^ AUTO ® # OR ♦ PROGRAM 0.
0 twice (TONE)
• To cancel during programming, press PROGRAM 0, then start from
the beginning.
• If 3 beeps sound during programming, a wrong key was pressed.
Start again from the beginning.
• If a power failure occurs, the mode will return to the factory preset
(TONE). Reprogram if necessary.