Panasonic EW3152 - Manual (Page 19)

STORING MEASUREMENT VALUES
This product can separately store 90 measurements
each for two persons.
After measurement, the QD CD will light.
Press the M/R
(memory/recall) button
with the number
corresponding to
the person for which measurements should be
stored.
Example: Person A: Press
C3D
Person B: Press
CD
Number
of stored
data
Storing is compieteci.
• Up to 90 measurement values can be stored.
When the memory Is full and additional values
are stored, the oldest value In memory will be
deleted and the new value will be stored.
• If measurements could not be taken properly
(the £ mark is shown instead of the blood
pressure value), measurement values cannot be
stored.
• However, If the
E
mark Is displayed for only the
pulse value, data can be stored.
To erase all measured values stored in memory:
1. Recall the measurement value for the person whose data you want to delete by pressing
that person's M/R (memory/recall) button.
2. Press the same M/R (memory/recall) button again, and hold it pressed until the
measurement values disappear (approximately 3 seconds or more).
* It Is not possible to erase single measurement values.
To switch off the blood pressure monitor,
prOSS the On/Off Start button.
• If you forget to switch it off, the blood pressure monitor
will switch off automatically after approximately 5
minutes.
19