3 configure the loudspeaker amplifier parameters, 1 log in to the configuration home page – CyberData Part #010861 930106D User Manual
Page 19

Installing the VoIP Loudspeaker Amplifier
Configure the Loudspeaker Amplifier Parameters
VoIP Loudspeaker Amplifier Operations Guide
930106D
CyberData Corporation
13
2.3 Configure the Loudspeaker Amplifier Parameters
To configure the loudspeaker amplifier online, use a standard web browser.
Configure each loudspeaker amplifier and verify its operation before you mount it. When you are
ready to mount a loudspeaker amplifier enclosure, refer to
Chapter A, “Mounting the Enclosure”
instructions.
All loudspeaker amplifiers are initially configured with the default IP settings indicated in
.
When configuring more than one loudspeaker amplifier, attach the loudspeaker amplifiers to the
network one at a time to avoid IP address conflicts.
2.3.1 Log in to the Configuration Home Page
1. Open your browser to the speaker IP address.
For the initial configuration of the speaker, open your browser to the default IP address:
http://192.168.3.10
Note
Make sure that the PC is on the same IP network as the loudspeaker amplifier.
2. When prompted, use the following default Web Access Username and Web Access Password
to access the Home Page (
):
Web Access Username: admin
Web Access Password: admin
Table 2-7. Factory Default Settings
Parameter
Factory Default Setting
IP Addressing
static
IP Address
192.168.3.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
255.255.255.0
Default Gateway
192.168.3.1