CyberData Part #010861 930106D - Manual (Page 15)

Installing the VoIP Loudspeaker Amplifier
Loudspeaker Amplifier Setup
VoIP Loudspeaker Amplifier Operations Guide 930106D CyberData Corporation
9
See Table 2-5 for details about connecting the loudspeaker amplifier.
2.2.3.1 Loudspeaker Type
The CyberData VoIP Loudspeaker Amplifier supports an 8 Ohm Bogen or equivalent unamplified
loudspeaker. See
Figure 2-4 .
Figure 2-4. Hornspeaker
2.2.3.2 Cabling/Wiring
You may connect a loudspeaker to a loudspeaker amplifier with a good quality speaker cable that is
limited to 25 feet in length.
Table 2-5. Loudspeaker Amplifier Connections
Connection Connection Details Location
Loudspeaker ● Use two binding posts for up to 0.083 inch
diameter loudspeaker wire. VoIP paging amplifier
Ethernet ● Use a RJ 45 cable. VoIP paging amplifier
AC
a
a.Consult a licensed electrician for local electrical code requirements.
● For a phase connection, use a press-down
connector for 14 AWG solid copper wire.
● For a neutral connection, use a press-down
connector for 14 AWG solid copper wire.
● For an earth/ground connection, use a screw-
down connector for 14 AWG solid copper wire.
AC panel