Panasonic WJ-300C - Manual (Page 6)

Note:
When using SEP position for dual video input,
each input is automatically terminated with
75 ohms regardless of the setting up of the
Termination Switch (11).
5. Input A Connector (INPUT A)
A composite video signal should be supplied to this
connector.
Note:
Refer to the operation of the Input Selection
Switch (4) and the Termination Switch (11).
6. Output A Connector (OUTPUT A)
Three (3) identical and isolated video signals are
provided to these connectors.
Note:
Refer to the operation of the Input Selection
Switch (4).
7. Output B Connector (OUTPUT B)
Three (3) identical and isolated video signals are
provided to these connectors.
Note:
Refer to the operation of the Input Selection
Switch (4),
6. Ground Terminal
9. Power Cord
10. Input B Connector (INPUT B)
A composite video signal should be supplied to this
connector.
Note:
Refer to the operation of the Input Selection
Switch (4) and the Termination Switch (11).
11. Termination Switch (75i) Hi-Z)
When a single video signal is supplied to
either the Input A Connector (5) or the Input
B Connector (10), set this switch to T S Q
position.When bridging or looping through the
input signal among the Input A Connector (5)
and the Input B Connector (10), set this switch
to Hi-Z position.
Note:
When the Input Selection Switch (4) is set to
the SEP position for the dual input, the Input
A Connector (5) and the Input B Connector
(10) are automatically terminated with 75 ohms
regardless of the setting up of the Termination
Switch (11).
-
5
-