Panasonic WJ-300C - Manual (Page 5)

1. Power ON/OFF Switch (POWER ON/OFF)
2. Power Indicator
This indicator lights when the power switch is turned
on,
3. Handle/Lock Ring (LOCK)
This ring should be used when the unit is mounted
on the rack,
4. Input Selection Switch (THR/SEP)
This switch is used when selecting the input signal
from single input or dual input,
(a) THR position
When a single video signal is supplied to the
Input A Connector (5) or Input B Connector (10),
set this switch to THR position (Fig, 1). This will
provide six (6] identical and isolated outputs
to the Output A Connector (6) and the Output
B Connector (7), The Termination Switch (11)
should be set to 75ii position (Fig. 1),
THR SEP
75ii Hi-Z~]
Fig, 1
Note:
When bridging or looping through the input
signal, set the Termination Switch (11) to Hi-Z
position (Fig. 2).
THR SEP
i
(b)
75n Hi-Z I
Fig, 2
SEP position
When the two (2) different video signals are
supplied to the Input A Connector (5) and the
Input B Connector (10), set this switch to SEP
position (Fig, 3). This will provide three (3)
identical and isolated outputs to the Output A
Connector (6) and the Output B Connector (7)
for each input,
THR SEP
75fi Hi-Z^
Fig. 3 ■
- 4 -