Panasonic WV-7230D - Manual (Page 5)

PRECAUTIONS ON INSTALLATION
This pan/tilt unit Model WV-7230D is designed for
indoor use. Avoid mounting it outdoors under the
eaves or any other place there rain or moisture could
be problem.
If panning unit is mounted upside down as shown
below, the image on monitor TV will also be upside
down. Therefore, remove the camera mounting plate
from the top of the camera and attach it to the bottom
of the camera.
A camera with various lenses and a camera housing
(Model WV-7110, 712ÛD and 7130D) can be used.
Select a location where the total weight is sufficiently
support and firmly fix the units onto plywood, gypsum
board, plaster board or concrete. Install the panning
head before mounting the camera on it.
Mount on flat surface - flat ceiling or mounting bracket
Model WV-7030.
Avoid a location which is susceptible to vibration, such
as close to a motor or ventilation fan.
INSTALLATION
CAUTION:
The following installation should be made by qualified
service personnel or system installers.
4. Mount the low voltage camera on the Mounting Plate.
If mount the zoom lens, use with the Zoom Lens fixing
plate WV- Q02 or WV-Q03.
1. Retighten the Cover Locking Screws and remove the
Cover.
2. When mounting directly to a flat ceiling:
• Make four holes for mounting the Pan/Tilt Head.
(Screws are not provided.)
• Holes in the head are 5/8” (8 mm).
3. When using on the mounting bracket (WV-7030)
• Use four hex head bolts, plain washers,
lockwashers and hex nuts (provided with the
WV-7030) as shown below.
• After wiring, replace the cover.
Hex Nut
Part (No.:XNG6GFMl
Mounting
Bracket
WV-7030
Plain Washer
Part (No.:XWG6FNl
Camera
5. Mounting a camera housing (WV-7130D) on the
Mounting Plate.
• Use four hex head bolts (3/16", M4), plain washers
and lockwashers (provided with the WV-7230D)
as shown below.
Plain Washer
(Part No.:XWG6FN)
Lock Washer
(Part No.: XWA6BFN}
Hex Head Bolt
(Part No.: XVG6C35FN)
- 4 -