Panasonic GENIUS 1100 NN-N688 - Manual (Page 36)

iis
_ -
;
Before Requesting Service
mM
Í All these things are normal:
The oven causes
interference with my TV.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, blow dryers, etc. It does not
indicate a problem with your oven.
The oven lights dim. When cooking with a power other than HIGH, the oven must cycle to
obtain the lower power levels. The oven light will dim and clicking noises
can be heard when the oven cycles.
Steam accumulates
on the oven door and warm
air comes from the oven
vents.
During cooking, steam and warm air are given off from the food. Most of
the steam and warm air are removed from the oven by the air which
circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
I accidentally ran my
microwave oven without
any food in it.
Running the oven empty for a short time will not damage the oven.
However, we do not recommend operating the microwave oven
without any food in it
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
Oven will not start cooking.
The words “DEMO MODE”
appear on the screen,
When the oven is turning
on, there is noise coming
from the glass tray._____
DEMO MODE was activated by
the Function pad.___________
The oven is not plugged In
securely.
Remove plug from outlet, wait
10 seconds and reinsert.
Circuit breaker or fuse is Reset circuit breaker or replace
tripped or blown. fuse.
There is a problem with the Plug another appliance into the
^ outlet. outlet to check if it is working.
Deactivate mode by using
Function pad (p. 8 - 9).
The door is not closed completely. Close the oven door securely.
:
Start Pad was not pressed after
. programming.
Press Start Pad.
\
Another program entered
already in the oven. Press Stop/Reset Pad to
cancel the previous program
and program again.
The program is not correct. Program again according to the
Operating Instructions.
Stop/Reset Pad has been pressed
. accidentally.
Program oven again.
The roller ring and oven bottom Clean these parts according to
-------- Ì
are dirty. Care of Your Oven (next page).
If it seems there is a problem with the oven, contact an authorized Servicenter.
If you have any questions or it seems there Is a problem with the oven,
contact PANASONIC CUSTOMER CALL CENTER for assistance.
1-800-211-PANA(7262) (9 a.m. - 9 p.m.. E.S.T., toll free).
- 3 4 -