How to use the spray feature – Panasonic NI-636E User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE AS A DRY IRON
1 Press the steam button down to the dry position
2 Place the iron vertically, set the selector dial to OFF
3 Plug in the iron
4 Set the temperature selector dial to the desired position
(Refer to the Fabric Ironing Chart in this manual on page 9)
5 (NI-636E / 686E Only) Preheat the iron usually in about 1 -2 minutes
(NI-436E / 486E Only) Preheat the iron until the indicator light goes out
HOW TO USE THE SPRAY FEATURE
Before using the spray feature, check the garment label for ironing
instructions because some fabrics may spot or stain with moisture
The
spray
feature
is
particularly
helpful
for
removing
stubborn
wrinkles and where extra dampening is needed The spray may
be used with steam or dry ironing
1 Simply pump the spray button when spray is desired If the
spray doesn't work immediately just keep pumping till it does
To get a finer spray, pump the button vigorously To get a coarser spray, pump the
button more slowly
For best results, use a quick, full stroke
Electronic AUTO SHUT-OFF FUNCTION (NI-636E / 686E Only)
1
When the iron is left unmoved with its soleplate facing down
or on Its side for approx 1 minute, the iron will automatically
shut off power to the heater by itself, and the Auto Shut-Off
Indicator Light goes out
When the iron is left unmoved on its heel rest for approx 10 minutes,
the iron will automatically shut off power to the heater by itself, and
Auto Shut- Off Indicator Light goes out
To turn the iron back on to resume ironing,
simply move the iron in any way until the
Auto Shut - Off Indicator Light goes on
Reheat the iron for about 1-2 minutes if
you have left the iron in its auto shut off
mode for 10 minutes or more
(Continued on page 8)
.; Licensed under U S patent No 4,686,352 and foreign counterparts
10
minutes
to ‘OFF' power
- 7 -