Leica Geosystems Leica DISTO A8 - Manual (Page 12)

9 Appendix Leica DISTO™ A8 1.1.0 gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
RC
ROK
PL
H
RUS
CZ
be adjusted with the PLUS - key {A, 3} or MINUS -
key {A, 11}. Through pressing the EQUAL - key {A, 5}
again the adjustment is confirmed. Now the value can
be stored as usual as a constant.
Historical Storage
Press STORAGE - key {A, 7} twice quickly and the
previous 30 results (measurements or calculated
results) are shown in reverse order. Using the PLUS -
key {A, 3} and the MINUS - key {A, 11} allows to
navigate in the historical storage. Press EQUAL - key
{A, 5} to take a result from the historical storage to
use for further calculations.
Timer
Press and hold TIMER - key {A, 4} until desired time
delay has been reached (5 - 60 seconds).
Press DIST - key {A, 1}. Once the key is released the
remaining seconds until measurement are displayed.
The last 5 seconds are counted down with a beep.
After the last beep the measurement is taken.
Appendix
Message Codes
All message codes will be displayed with either "InFo"
or "Error".
The following mistakes can be corrected:
InFo Cause Remedy
154 Transverse tilt < 20° Hold the instrument
without any trans-
verse tilt
204 Calculation error Repeat procedure
206 No endpiece detec-
tion Attach the endpiece
properly. If error still
occurs, replace the
endpiece.
252 Temperature too
high Cool down instrument
253 Temperatur too low Warm up instrument
255 Receiver signal too
weak, measurement
time too long,
distance > 100 m Use target plate
256 Received signal too
powerful Use target plate
(grey side)
257 Wrong measure-
ment, ambient
brightness too high Use target plate
(brown side)
260 Laser beam inter-
rupted Repeat measurement
Error Cause Remedy
Hardware error Switch on/off the
device several times
and check if the
symbol still appears. If
so please call your
dealer for assistance.