Leica Geosystems Leica DISTO pro /pro4a - interface manual - Manual (Page 9)

3350-RUEA Error! Style not defined.
I:\DIST\Marketing\0Temp\Doc\interfaceManual111_en.docSeite 9 von 18 Erstelldatum: 17.06.03
4 S
ETS OF
C
OMMANDS IN
O
FFLINE
M
ODE
(S
TANDARD
-M
ODE
)
4.1 ON-command (a)
Function:
Power on or reset the DISTO TM pro 4 / DISTO TM pro 4 a. Same function as com-
mand “c“
Input:
a
Output:
?
or @Exxx
4.2 Online-command (EXT or A)
Function:
Switches on the extended set of commands (online mode) and switches to
online mode (all applications are off in this mode).
Input:
EXT or A
Output:
?
or @Exxx
4.3 OFF- command (b)
Function:
Switches off DISTO TM pro 4 / DISTO TM pro 4 a .
Input:
b
Output:
?
or @Exxx
Remarks : Short waiting period of about 500ms after switching off before they can be
switched on again.
4.4 STOP/CLEAR- command (c)
Function:
Stops current distance or signal measurement.
Input:
c
Output:
?
or @Exxx
4.5 Distance measurement (g)
Function:
Triggers single distance measurement.
Input:
g
Output:
WI31 WI51
or @Exxx
4.6 Tracking (h)
Function:
Triggers continuous distance measurement. Measurement is continued until
next command or until an error occurs.
Input:
h
Output:
WI31 WI51
or @Exxx
Remarks: Interface must be set to 9600 baud or higher to fully exploit the measuring
rate.
4.7 Signal measurements (k)
Function:
Triggers continuous distance measurement. Measurement is continued until
next command or until an error occurs.
Input:
k
Output:
WI53
or @Exxx
Remarks: Interface must be set to 9600 baud or higher to fully exploit the measuring
rate.
4.8 Laser (o, p)
Function:
Switch laser on/off.
Input:
o
Switch laser on.