Dynon Avionics EFIS-D60 Pilots Users Guide - Manual (Page 24)

Operation
5-2 EFIS-D60 Pilot’s User Guide
The current indicated altitude is preserved across a power cycle. When powered down, the instrument saves the indicated
altitude. When it is powered up again, the instrument automatically adjusts the altimeter setting by exactly enough to
preserve that saved value. This is not a replacement for modifying the altimeter setting by the pilot before takeoff; it
makes it very close to the correct value, minimizing the amount of adjustment needed. To turn auto-set on or off, enter
the SETUP > BARO menu and set the ADJUST AT BOOT option to ON or OFF.
SETUP – Setting Preferences
Enter the SETUP menu to make changes to preferences. Many of the settings in this menu are used only during initial
installation of the unit and are described in the EFIS-D60 Installation Guide. The preferences and settings that are
relevant to the pilot and in-flight operation are explained below.
CHANGE DISPLAYED UNITS
In the UNITS submenu, you may change the system-wide
displayed units for the following units. See the
following table for a list of available units for
each displayed parameter.
Parameter Available units
Airspeed (IAS) Knots, miles/hour, kilometers/hour
Altitude (ALT) Feet, meters
Barometric Pressure (BARO) inHg, mbar