CANOGA PERKINS L357 ESU - Manual (Page 7)

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6942590 Rev A Page 7 of 8
Canoga Perkins Corp. EdgeAccess Ethernet Media Converter 30-Nov-2005
Model L357-1564 V02.00 F19 Standalone
09:31:28
----------------------------------FUNCTIONAL CONFIGURATION----------------------
Local Remote
Chassis/Slot Standalone Offline
User Port Speed/Duplex Link Down
Switch Settings:
User Port Speed/Duplex Autonegotiate
Side Band Mgmt
Disabled
LLF Extension to User Disabled
LLF User to Extension
Disabled
1) Configuration Option Control Software
2) User Port Setting
100M/Full
3) Ext Port Setting 1000M/Full
4) RMTF Disabled
5) Link Loss Echo Disabled
6) Link Loss Fwd Disabled
Select [1-6]:
------------------------------------Messages------------------------------------
Alarm Outputs: None
Figure 11. Functional Configuration screen
Step 7: Cable Connection
Once the changes are made to the modules, the UTP (Unshielded Twisted Pair) or fiber optic
cables can be installed. Remember that the USR port is the port connected to your local/client
device and the EXT port is the port facing the network/trunk. Connect the fiber to the EXT port.
Figure 12. Fiber optic and UTP cable connection
Step 8: IP Address/Subnet Mask/Default Gateway Set-up
From the System Configuration menu, type “5” then “enter” to access the IP/VLAN
Configuration screen. To configure the IP address, select “5,” press “enter,” and type the IP
address you wish to assign to the unit. Press enter to accept the changes. The Subnet Mask and
Default Gateway must be entered at this point as well.