CANOGA PERKINS 9160 10 Gigabit Ethernet Network Interface Device User Manual

Page 27

3. To finish setting up V1-Trap, V2-Trap, or V2c-Inform notification, type the community name, up

to 10 characters, and press .

4. To finish setting up SNMPv3-Trap notification, press to cycle through the options for

these parameters:

• Security Name: The name of the user account at the DMM.
• Security Level: Can be "No Auth/No Priv" means no user authentication or encryption for

the message; "Auth/No Priv" means authentication by user name, but no encryption for the
message; "Auth/Priv" means authentication by user name and encryption for the message.

5. To finish setting up SNMPv3-Inform notification, either type a value and press or press

to cycle through the options for these parameters:

• Security Name: Enter the name of the user account at the destination, up to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination; view it at the destination

configuration; 64 Hex characters.

• Authentication Protocol: Set how to authenticate the notification; can be MD5, SHA, or

None.

• Authentication Password: Enter the password that generates the authentication key for the

message if the authentication protocol is MD5 or SHA; 8 to 15 characters.

• Authentication Key: Shows the key that authenticates the notification for MD5 or SHA

Authentication Protocol; this is generated automatically for the Authentication Password, but
can be changed if the destination uses a different Authentication Key generation algorithm;
16 Hex characters for MD5 protocol or 20 Hex characters for SHA protocol.

• Privacy Protocol: Set the protocol for encrypting the notification; can be DES (authentication

Protocol must be MD5 or SHA) or None

• Privacy Password: If the privacy protocol is DES, enter the password that generates the

encryption key for the message; 8 to 15 characters

• Privacy Key: Shows the key that encrypts the message for DES Privacy Protocol; this is

generated automatically for the Privacy Password, but can be changed if the destination uses
a different Privacy Key generation algorithm; 16 Hex characters

• Security Level: Can be "No Auth/No Priv," no user authentication or encryption for the

message; "Auth/No Priv," authenticates by user name, but no encryption for the message; or
"Auth/Priv," authenticates by user name and encrypts the message.

• Retries: How many times to try to resend the message if not acknowledged; Range is 0 to 10
• Timeout in Seconds: How long to wait, in seconds, for an acknowledgement before retrying;

Range is 1 to 30

6. To delete a destination, type

and press , then at the prompt, highlight the IP Address for

that Host and press . The host table appears again with your changes.

7. To return to the System Menu, press .

9160 10 Gigabit Ethernet Network Interface Device

3-15