Cisco 350 User Manual

Page 10

In the Select Components screen, make sure the client utilities that you want to install are

selected and any that you do not want to install are deselected. Click Next.

In the Select Program Folder screen, click Next to allow icons for the client utilities to be

placed in the Cisco Systems, Inc. folder.

In the Setup Complete screen, perform one of the following:

— If you selected no server-based authentication in Step 5, select Launch the Aironet

Client Utility and click Finish. ACU opens so you can configure your client adapter. If

you set a WEP key in CEM and enable WEP using ACU, the WEP key must match the

number and value of the WEP key used by the Access Point.

— If you selected LEAP or EAP server-based authentication in Step 5, select Yes, I want

to restart my computer now, remove the CD from your computer’s CD-ROM drive,

and click Finish. When the computer reboots, enter your username and password at

the network logon screen. The client adapter will be authenticated and assigned a

session-based WEP key, provided your client adapter is configured to associate to an

EAP-enabled Access Point.

Refer to the Cisco Aironet Wireless LAN Adapters Software Configuration Guide for

instructions on how to use each utility.

Note

To install and use the client utilities on Windows NT or Windows 2000 systems, you

must log onto the system as a user with administrative privileges. The utilities do not install

or operate correctly for users not logged in with administrative rights.

Safety Information for the Cisco Aironet Wireless LAN Adapters

The Federal Communications Commission (FCC) with its action in ET Docket 96-8 has

adopted a safety standard for human exposure to RF electromagnetic energy emitted by FCC

certified equipment. Cisco Aironet 340 and 350 series products meet the uncontrolled

environmental limits found in OET-65 and ANSI C95.1, 1991. Proper operation of this radio

according to the instructions found in this manual and the hardware and software guides on

the Cisco Aironet Series Wireless LAN Adapters CD will result in user exposure that is

substantially below the FCC recommended limits.

•

Do not touch or move the antenna(s) while the unit is transmitting or receiving.

•

Do not hold any component containing a radio such that the antenna is very close to or

touching any exposed parts of the body, especially the face or eyes, while transmitting.