C. Crane SKWV - Manual (Page 16)

CC SKYWAVE Page 16
Troubleshooting Guide
The CC Skywave will not turn on and none of the buttons work:
The Lock button: that is located on the front of the radio may be activated. When
activated, a key icon will show on the display screen. Push lock button for 2 seconds to
resume normal operation of the radio. (Please see ‘Lock Button’ on page 9.)
My radio shuts off after just a few seconds:
Low batteries can cause this situation. Replace them with a new set of batteries.
Stations won’t hold in memory:
The memory button settings are being overwritten. When recalling a station from memory, if
you hold the memory button down too long it will program the current station over your
previously stored station. To recall a station that has been stored in memory, always press and
release the button quickly. To program a new station into memory, tune to the desired station
and then press and hold the memory button for two seconds until you hear a beep.
Poor reception on AM band:
Rotate the radio until the reception is best. Many buildings that use brick, metal, or stucco can
absorb or reflect the AM signal. Computers and other electronic equipment, including
fluorescent lights, can cause noise that interferes with your AM reception. Move the radio to a
different place to see if that helps. Additional noise may affect a weak signal. There are several
bandwidth filters which can help to reduce interference. Select which one sounds best by
pressing the “BAND WIDTH” button. For even more reception, use an external AM antenna,
available at
www.ccrane.com
Poor reception on FM, Weather, and Air band:
Fully extended the whip antenna and adjust its orientation to obtain the strongest signal. You
may be able to get an even better signal by switching to FM mono. Press the STEREO button
change between FM Stereo and FM Mono. For addition reception, use an external FM antenna
available at
www.ccrane.com