BendixKing KLX 135A - Quick Reference Guide User Manual
Page 2
-2-
D
To go Direct To a waypoint:
1. Press the
D
button. The Direct To (DIR) page will be displayed with a waypoint
field.
2. Enter desired waypoint using right concentric knobs.
3. Press
F
to view waypoint information. Press
F
again to confirm. This initi-
ates the Direct To—your D-bar will be centered, and you’re on your way!
4. Alternatively, display desired waypoint on APT, VOR, NDB or SUP page, or move
the cursor over desired waypoint in the active flight plan, then press
D
, then
press
F
to confirm.
To create a Flight Plan:
1. Select the active Flight Plan (FPL 0) or one of the stored Flight Plans (FPL 1
through FPL 9) on the screen.
2. Delete existing waypoints from the Flight Plan as necessary by placing the cursor
(
B
) over the identifier, pressing
E
, and then pressing
F
.
3. If you wish to insert a waypoint identifier between two other waypoints, place the
cursor (
B
) over the waypoint you wish for the new waypoint to precede.
4. With the cursor on, enter the desired waypoint identifier and press
F
.
5. The waypoint page for the selected identifier will be displayed. If this is the way-
point you intended to enter, press
F
again.
6. Repeat the waypoint entry process as needed for your Flight Plan.
To calculate the winds aloft:
1. Use the CAL 3 page to calculate the present pressure altitude.
2. Use the CAL 5 page to calculate the present true airspeed (TAS).
3. Turn to the CAL 6 page and enter the present aircraft heading. The headwind or
tailwind component of the wind, and the wind vector (direction and speed) will be
displayed on the last two lines of the CAL 6 page.
KLX 135A 5/16/03 2:48 PM Page 4