Kidde i12010S - Manual (Page 16)

-Green LED
The green LED will flash as described below under the following
conditions:
– Standby Condition (powered by AC and battery backup):
The LED will be constantly on.
– Standby Condition (powered by only battery backup):
The LED will flash every 60 seconds.
– Smoke Alarm Memory Condition: The LED will flash
every second during alarm. When the alarm condition
goes away, the originating alarm unit will flash the LED
every 16 seconds until the test/reset button is pressed,
thus resetting the alarm.
– Initiating Alarm condition: 1 second flash rate during the
alarm, which indicates this unit initiated the alarm.
– Trouble Fault/Error mode: 1/2 second flash rate (AC
powered only). Helps owner locate the mysterious
chirping unit
– HUSH MODE Condition: The LED will flash every 2
seconds while the alarm is in HUSH mode.
Operating Instructions
14
1210-7201-01(i12010S)_V3.qxd:_ 2014.2.20 3:19 PM Page 16