Kidde 0976 - Manual (Page 9)

A missing or improperly installed battery will prevent the battery carrier from
closing and result in improper alarm operation.
This smoke alarm uses a 9V carbon zinc battery (alkaline and lithium batteries
may also be used). A fresh battery should last for one year under normal operat-
ing conditions.
This alarm has a low battery monitor circuit which will cause the alarm to
“chirp” approximately every 30-40 seconds for a minimum of seven (7) days
when the battery gets low. Replace the battery when this condition occurs.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM
REPLACEMENT.
(These batteries are available at many local retail stores).
Carbon-zinc type: EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604S
Alkaline type: ENERGIZER 522; DURACELL MN1604 OR MX1604;
GOLD PEAK 1604A PANASONIC 6AM6, 6AM-6, 6AM-6PI,
6AM6X, AND 6LR61 (GA)
Lithium type: ULTRALIFE U9VL-J
NOTE: WEEKLY TESTING IS REQUIRED!
NOTE: IF AFTER BATTERY REPLACEMENT THE ALARM CONTINUES TO
CHIRP, PUSH THE TEST BUTTON. THE HUSH
® FEATURE MAY HAVE BEEN
ACTIVATED ACCIDENTLY WHILE CHANGING THE BATTERY AND PUSHING
THE TEST BUTTON WILL END THE HUSH
® CYCLE.
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUCTIONS
PRINTED ON THE BACK OF THE ALARM AND USE ONLY THE BATTERIES
SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL
EFFECT ON THE SMOKE ALARM.
PRESS OPEN INSERT