Sangean WFT-1D+ (V1) - Manual (Page 36)

35
DRC (Dynamic Range Control) - Digital Radio (DAB plus)
DRC can make quieter sounds easier to hear when your radio is listened
in noisy environment. Not all the stations support DRC function.
1. Ensure the radio is on and in DAB plus (Digital Radio) mode.
2. Press the BACK button to go to the DAB plus (Digital Radio) menu.
3. Rotate the Turning knob until “DRC” is highlighted on the display,
and press the Turning knob.
4. The display will show:
DRC high: DRC level is set as sent by broadcaster.
DRC low: DRC level is set to 1/2 that sent by broadcaster.
DRC off: DRC is off.
Rotate and press the Turning knob to make the selection.
Station order setup - Digital Radio (DAB plus)
There are 3 station order settings which are alphanumeric,
ensemble and valid. The default of your radio is alphanumeric.
1. Ensure the radio is on and in DAB plus (Digital Radio) mode.
2. Press the BACK button to go to the DAB plus (Digital Radio) menu.
3. Rotate the Turning knob until “Station order” is highlighted on
the display, and press the Turning knob.
4. Rotate and press the Turning knob to make the selection of:
Alphanumeric: Arranges your stations by alpha-number like
A…Z 0…9.
Ensemble: Arranges each station due to multiples.
Valid.: Shows the stations for which a signal can be found.
FM Radio
To listen to the FM radio, there are 3 ways to enter Internet
Radio mode, after turning on the radio:
1. From the menu selections go to > Main menu > FM or
2. Press the BAND button until you see “FM”, or
3. Press the FM button on the remote control.
The radio will play the last played radio station. If you would like to
select other stations, follow the instruction below.
To change FM stations:
1. Rotate the Turning knob on the radio clockwise or counter clockwise
or press the TUNE+/TUNE- buttons on the remote to
increase/decrease the radio frequencies. Or,
2. Press the Turning knob on the radio or on the remote control to
scan and go to the next available FM station.