Quickspecs, Standard features – Compaq SCSI User Manual
Page 5
QuickSpecs
Compaq ProLiant ML330
Generation 2 (G2)
DA-10961
World Wide — Version 18 — June 27, 2002
5
Standard Features
Rack Airflow Requirements
•
Rack 9000 and 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The Compaq 9000 Series Rack and the new 10000 Series Racks
provides enhanced airflow for maximum cooling, allowing these racks to be fully loaded with servers
using the latest processors.
•
Rack 7000 series Cabinets
When installing a server with processors running at speeds of 550 MHz or greater in Compaq Rack
7000 series racks with glass doors (165753-001 (42U), and 163747-001 (22U)), the new processor
technology requires the installation of Compaq’s new High Airflow Rack Door Inserts (327281-B21
(42U), 327281-B22 (42U 6 pack), or 157847-B21 (22U)) to promote enhanced airflow for maximum
cooling.
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure adequate airflow
and to prevent damage to the equipment:
o
Front and rear doors: If your 42U server rack includes closing front and rear doors, you must
allow 5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to permit
adequate airflow (equivalent to the required 64 percent open area for ventilation).
o
Side: The clearance between the installed rack component and the side panels of the rack must
be a minimum of 7 cm (2.75 inches)
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling that can
lead to thermal damage.
Note: For additional information, refer to the Setup and Installation Guide or the Documentation CD provided with
the server, or to the server documentation located in the Support section at the following URL:
Service and Support
Compaq Services provides a one-year, limited warranty, including Pre-Failure Warranty (coverage of hard drives,
memory and processors) fully supported by a worldwide network of resellers and service providers. Compaq
technical assistance is available 7x24, toll free in the United States and Canada. Telephone support services may
be covered under warranty or available for an additional fee.
Note: Limited Warranty includes 1 year Parts, 1 year Labor, 1-year on-site support.
A full range of CarePaq
packaged hardware and software services:
−
Installation and start up
−
Extended coverage hours and enhanced response times
−
System management and performance services
−
Availability and recovery services
Note: For more information, customer/resellers can contact
Please see the following URL regarding Warranty Information For Your Compaq Products:
For additional information regarding Worldwide Limited Warranty and Technical Support, please see the following
URL:
ftp://ftp.compaq.com/pub/supportinformation/ejourney/176738.pdf
Note: Certain restrictions and exclusions apply. Consult the Compaq Customer Support Center at 1-800-345-1518
for details.