Sangean RCR-2 (V1) - Manual (Page 14)

13
Alarm with HWS alarm buzzer
1. Select alarm system 1 or 2 by pressing the alarm 1 or 2 button
(11 or 10). Display will blink selected alarm system symbol.
2. Press alarm SET button 13, display will blink both alarm hour and
alarm mode with a beep.
3. Press alarm mode button 17 to select alarm buzzer mode until
display shows .
4. Press + or – to adjust required alarm hour then press SET button
again, display minute digits will blink. Press + or – button to adjust
required alarm minute.
5. Press week day selection 1-7 ( Sunday – Saturday ) to select
required alarm week days. Display will show the days of the week
on which you wish to be woken by the buzzer alarm.
6. Press alarm button 1 or 2 to confirm all the alarm set with a beep.
Display will show indicating HWS buzzer alarm is set .
Note:
If the alarm week day (s) is not selected, display will blink all the
week days and , the alarm will not be activated.
Cancel alarm setting.
If you do not wish to be woken up at the alarm time you have set,
you can cancel the alarm function.
1. Select alarm system 1 or 2 by pressing the alarm 1 or 2 button
(key 11 or 10).
2. Press SET button , the alarm mode symbol will blink with a beep.
3. Press alarm MODE button 17 one or two times (depending you
were in alarm radio or alarm buzzer status ) till display blink .