Sangean DDR-31BT (V1) - Manual (Page 32)

3
Factory reset
If your clock radio fails to operate correctly or some digits on the display
are missing or incomplete, carry out the following procedures.
. Press and release the On/StandBy button to switch on your clock radio.
. Press and hold the Advanced button to enter the setting.
3. Press the Tuning Up or Down buttons until the display shows “System”.
4. Press and release the Select button to enter the adjustment mode.
5. Press the Tuning Up or Down buttons until the display shows “Factory
reset”.
6. Press and release the Select button to enter the Factory reset menu.
7. Press the Tuning Up or Down buttons to select the option of or
.
8. Press the Tuning Up or Down buttons to select YES, then press and
release the Select button to start the Reset, the display will appear
“Restarting…”.
9. A full reset will be performed, the station list and presets will be erased.
The display will show “Welcome to Digital Radio“ for a few seconds
and then the flash clock digits and the display will show “Time is not
set”. When the factory reset is complete, you can set new settings.
In case of malfunction due to electrostatic discharge, reset the product
(reconnection of power source may be required) to resume normal
operation.