Sangean RCR-10 (R3) - Manual (Page 30)

4. Rotate the Tuning control to choose the required alarm type, and then
press and release the Tuning control to confirm the setting. The alarm
can be set to buzzer, iPod, FM or AM. When radio mode is selected,
the radio frequency and the preset number on the display will begin
to flash. Rotate the Tuning control to adjust the required radio
frequency or the required preset number for the radio alarm, then
press and release the Tuning control to confirm the setting.
Note:
If the alarm type selected is iPod but your iPod is not docked when
the alarm is sounding, the buzzer alarm will be used instead.
5. Rotate the Tuning control to choose the required sound level for the
alarm. Press and release the Tuning control to confirm the setting.
6. The alarm has now been set. Press and release the Tuning control
again, and the radio will revert to normal display. Active alarms are
shown using alarm indicator on the display.
When the alarm sounds
To cancel a sounding alarm, press and hold the Alarm 1 or Alarm 2 but-
ton until the alarm indicator on the display disappears.
When the buzzer alarm activates, the alarm will start softly and gradu-
ally increase in level. It will sound for 1 minute and silence for 1 minute
in repetition for 60 minutes unless cancelled. The radio will sound non-
stop at the selected time for up to 60 minutes for other alarm types.
When the radio alarm is activated, the alarm will go off in Humane Wak-
ing System. It will increase its volume in 0.5increments from 0 to your
set volume.