Sangean RCR-10 (R3) - Manual (Page 23)

GB
Navigating your iPod
To navigate your iPod menus to make selections or to change settings,
you should use your iPod controls. The radio controls can be used for
Menu / Select, Previous / Next, Fast Rewind / Fast Forward and Play /
Pause functions.
1. Use the Menu button to navigate to higher level menus on your iPod.
2. Rotate the Tuning/Seek/Select control as required to move up or down
a menu screen on your iPod.
3. Press the Tuning/Seek/Select control to choose the highlighted on
screen menu item. If this item is a lower level menu item, you May
then navigate further using the Tuning/Seek/Select control.
Playing an audio file on your iPod
1. When you have found the required item, use the Tuning/Seek/Select
control on the radio to start the iPod playing.
2. Adjust the volume to the required setting using the Volume control on
your radio.
3. To pause playback press the Play/Pause button. To resume playback
press the Play/Pause button again.
4. iPods do not have a Stop button (they use the Pause function). To play
an alternative selection, use the iPod menus to make the selection
using the Play/Pause button to stop playing the current item if needed.
5. If it was previously playing, your iPod will switch on and continue
playing from where it was previously stopped.