Assembly of the wing, Cutting out the body and painting – OFNA Racing Jammin X1 CRT PRO User Manual

Page 25

Text mode
Original mode

3x12mm
Hex Screw

40672
Wing

Drill two 7mm holes for
mounting.

40542
Countersunk
Plastic Washer

3mm
Nylon Nut

ASSEMBLY OF THE WING

..........X2

94004
3x12mm
Hex Screw

94041
3mm
Nylock Nut

Cut out the body as shown.

Use a neutral detergent to
remove any dirt and oil.

Mask the windows from
the inside with masking tape.

Paint the body with
polycarbonate spray paints.

Spray Paint

Before cutting and making holes on the body,
put the unpainted body on the chassis
to confirm the mounting position and
location for holes and cutouts.

Making two holes in the front and
one hole in the rear for body posts.

8mm

Cut out for engine.

Hole for fuel tank.

CUTTING OUT THE BODY AND PAINTING

10803
Body Reamer
( Not included)

40620
Body w/
Decals