Axesstel AXW-D1900 - Manual (Page 8)

CDMA 1xEV-DO Wireless Broadband Modem
AXW-D800 / AXW-D1900
- 8 - Connecting the World Now
Connection using Ethernet port
1. Power off the unit before connecting the cables.
2. Connect CAT-5 Ethernet cable to Ethernet port of EV-DO Modem.
3. Connection type switch next to the Ethernet port should be set to
Ethernet. If not, slide the switch toward the Ethernet port.
4. Connect other end of Ethernet cable to the RJ-45 connector of
Ethernet network adapter or a network device.
5. Connect the Power Adapter to the power connector of EV-DO modem.
Plug the AC plug into a power outlet.
6. Turn the power ON, using the power switch next to the power jack.
The LED labeled “Power” light on.
7. Wait for few seconds for EV-DO modem to search for the service. The
LED labeled “Signal” turns to Red, Orange, or Green when signal is
acquired.
Configuring Your PC
The EV-DO modem’s Ethernet is configured with DHCP by default. This
means that IP address of your PC is automatically assigned by the EV-DO
modem.
If the PC’s cannot get IP address and cannot make connection to internet.
Check the TCP/IP setting of your “Local Area Connection”.
1. Click the Start button, select
Settings, and select Control
Panel.