Pro-Link 47% OMU 350 B14032 - Manual

U35 MATERIAL SAFETY DATA SHEET N/A=Not Applicable
Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1200) Effective Date: 1/09 Revision: n/a
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Manufacturer’s Name:
Misco Products Corporation
Manufacturer’s Address:
1048 Stinson Drive Reading, PA 19605
Manufacturer’s Phone #: (610) 926-4106
Product Name: Crystal Cote 350
Generic Name: Polyurethane Wood Finish
Chemical Family: Solvent Urethane Blend
Formula: Proprietary
Supplier’s Name:
Supplier’s Address:
Supplier’s Phone #:
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Mineral Spirits 64742-47-8 30 to 35 300 ppm 100 ppm N/A
Regular Mineral Spirits 64741-41-9 10 to 15
Oil Modified Urethane Resin N/A 50 to 55
Xylene 1330-20-7 1 to 5 100ppm 100ppm 150ppm
Ethylbenzene 100-41-4 0.1 to 1 100ppm 100ppm 125ppm
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Boiling Point (°F): 282 F. Initial Specific Gravity: 0.91
Vapor Pressure: 6 mm Hg @ 68 F. Vapor Density (Air=1): 5.1
% Volatile: 45+ pH: N/A
Solubility in Water: Nil Evaporation Rate (Water=1): 0.6
Physical Description: Moderately viscous yellow liquid with characteristic solvent odor.
VOC Content (Subpart D §59.406) : < 350 grams/liter
Flash Point (Method Used): 100°F. (TCC)
Upper Explosion Limit: 6.0% Lower Explosion Limit: 1.0%
Extinguishing Media: Foam, CO
2
, dry chemical.
Special Firefighting Procedures: Do Not Use Water.
Unusual Fire and Explosion Hazards: Drums heated by fire can explode.
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: May occur through oxidation, leading to exothermic reaction. Heat generated by oxidation may lead to
spontaneous combustion of materials such as rags, paper towels, etc., used for clean-up
Hazards Decomposition Products: Carbon monoxide possible if burned. Incompatibility (Materials to Avoid): Strong oxidizers.
SECTION 6-STORAGE AND HANDLING INFORMATION
Combustible liquid. Avoid contact with heat, spark or open flame. Eye irritant. May cause skin irritation. Keep out of reach of children. For use by trained personnel only. Keep
unauthorized personnel away when applying to floor. Keep container closed during storage. For institutional and industrial use only. Avoid contact with eyes, skin and clothing.
Wear rubber gloves when handling. Wear protective boots when applying to floors. Avoid breathing of vapors. Use in well-ventilated area.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure:
Skin: Prolonged or repeated contact may cause irritation, defatting, or dermatitis.
Eyes: Eye irritant. May cause redness, swelling, or blurred vision.
Inhalation: May be irritating to the nose, throat, and lungs. Prolonged breathing can
cause headache, nausea, dizziness, weakness, and fatigue. Some reports have associated
repeated and prolonged occupational overexposure to solvents with permanent brain and
nervous system damage.
Ingestion: Can cause irritation of the gastrointestinal tract, nausea, vomiting, and
diarrhea. Aspiration of material into the lungs can cause pneumonitis.
Other: May cause liver damage and/or kidney damage.
Contains ethylbenzene, which has been determined by NTP to be an animal carcinogen
with no known relevance to humans. IARC has classified ethylbenzene as possibly
carcinogenic to humans (2b) on the basis of sufficient evidence of carcinogenicity in
laboratory animals but inadequate evidence of cancer in humans.
Respiratory Protection: NIOSH approved hydrocarbon cartridge or self-contained
apparatus when used in enclosed areas.
Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-
gredients below acceptable limit. Open doors and windows when handling and during
drying period.
Protective Gloves: Solvent proof rubber recommended.
Eye Protection: Safety glasses recommended.
Other Protective Equipment: Eye wash station should be available nearby. Protective
clothing and footwear (rubber boots) when using on floors.
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Skin: Remove contaminated clothing. Wash with soap and water. Seek medical attention
if irritation persists.
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical attention.
Inhalation: Get to fresh air. If breathing is difficult, give oxygen. Seek medical attention
if symptoms persist.
Ingestion: Do not induce vomiting. Seek medical attention immediately.
Steps to be taken in Case Material is Released or Spilled: Shut off all ignition
sources. Ventilate area well. Floors will become slippery. Avoid walking in product.
Keep unessential personnel away. Mop up or otherwise absorb and hold disposal.
Avoid discharge to sewer or open waterways.
Waste Disposal Method: Any method in accordance with local, state and federal laws.
Best method is to recycle or reuse for intended purpose. If discarded, this material and
containers should be treated as hazardous waste based on the characteristic of
ignitability as defined under federal RCRA regulations (40 CFR 261). Materials used
to absorb product should be soaked in water-filled containers or rinsed with water prior
to discarding in trash receptacles. Do not dispose of into storm drain, stream, river or
to ground. Rinse container thoroughly before discarding in trash.
SECTION 10-REGULATORY INFORMATION
SARA Title III - Section 311/312 -Hazard Categories: Domestic Shipping Information: HMIS Hazardous Materials
Yes - Fire Hazard FOR CONTAINERS > 1 Gallon : Floor Coating Identification System
No - Sudden Release of Pressure Hazard Health 2
No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Not Available in this size Flammability 2
Yes - Immediate (acute) Health Hazard Reactivity 1
Yes - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Not Available in this size Personal Protection D
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and of 40 CFR 372.
CAS# Chemical Name Percent by Weight
1330-20-7 Xylene 1 - 5
100-41-4 Ethylbenzene 0.1 – 1.0
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
100-41-4 Ethylbenzene 0.1 – 1.0
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the application of this information, or the safety and
suitability of our products either alone or in combination with other products. It is the responsibility of the user to provide a safe workplace, using the health and safety information contained herein as a guide.
This company will accept no liability for damages or loss incurred from the improper handling and use of this product
Pro-Link, Inc.
Canton, MA 02021
1-800-74-LINKS
47% OMU 350 Finish