Lithofin wax-off, 9 physical and chemical properties, 10 stability and reactivity – Pro-Link Lithofin Wax-Off 120005 User Manual
Page 4
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin WAX-OFF
4
Protection of hands:
Wear chemically resistant protective gloves (tested according to DIN EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection:
Chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR
1910.133
Body protection: Protective work clothing.
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Liquid
Color: Colorless, clear
Odor: Aromatic
Value/Range Unit Method
Change in condition
Melting point/Melting range:
undetermined
Boiling point/Boiling range:
> 130 ° C
Flash point:
> 23 ° C
Auto igniting:
Product is not self igniting.
Danger of explosion:
Product is not explosive. However, formation of
explosive air/vapour mixtures are possible.
Explosion limits:
Lower:
~ 0.6 Vol %
Upper:
~ 8.0 Vol %
Density:
at 20° C ~ 0.9 g/cm³
Solubility in / Miscibility with Water:
Insoluble
pH-value:
not applicable
Viscosity:
dynamic:
at 20° C < 30 s
—————————————————————————————————————————————
10 Stability and reactivity
Thermal decomposition / conditions to be avoided:
No decomposition if used and stored according to specifications.
Dangerous reactions No dangerous reactions known
Dangerous products of decomposition:
In the case of fire or at high temperatures the formation of the following decomposition products is
possible: Carbon monoxide and carbon dioxide
—————————————————————————————————————————————